ACCURA TourZ x Extreme Driver Shaft Review
By Russ Ryden, Fit2Score, A Dallas Fort Worth Club Fitter & Club Maker
The Golf Center at the Highlands, Carrollton Texas
The ACCRA Tour Z has been a staple in the ACCRA product line. The Tour Z Extreme is an updated version, using higher density prepreg and Kevlar in the tip.There are two models designed to compliment each other. The Tour ZX 400 series exhibits a profile known to produce a mid launch low spin. The TourZx 200 Series is typical of a higher launch higher spin design. The stiffness is very consistent across weights. The shafts do not get noticeably stiffer as they get heavier. Paring the TourZx 200 in a fairway with a TourZx 400 in a driver creates a great combination for most golfers. A more penetrating lower spinning drive and a higher launching, higher spinning flight in a fairway.
The discussion between Woody Lashen, a long time Fit2Score Affiliate and Gawain Robertson, do owner of ACCRA golf gets to the TourZ at the 10:30 mark. It was shot at the 2016 PGA merchandise show.
To read this review, you must register .
Show that you enjoy learning about golf shafts with our special, off season annual subscription of $10. Ten dollars is less than the cost of a sleeve of premium golf balls or a bucket of range balls. Your support will keep Golf Shaft Reviews going and growing. This website is the only comprehensive information source about golf shafts available to the public. I do not receive compensation from the shaft companies nor clutter the site with ads.
Information provided at registration will NEVER be shared with ANYONE. To be notified of new reviews, follow DevotedGolfer on facebook.
Enjoy and Good Golf,
Russ
- - -